Hardened steel cutting teeth for diaphragm wall grab excavation equipment
| Parameter | Typical range | Notes & selection driver |
|---|---|---|
| Hardness | 55-60 HRC surface | |
| Service Life | 150-400 operating hours depending on soil conditions | |
| Weight Range | 2-8 kg per tooth | |
| Mounting Type | Bolt-on or weld-on | |
| Tooth Profile | Chisel, conical, or tiger |
Ranges are indicative industry figures for RFQ preparation, not a supplier commitment. Confirm every value and standard with the legal manufacturer before ordering.
This component is used in the following industrial products
A practical evidence checklist for RFQ preparation and supplier evaluation.
Compare the published product scope and source details, then include your specifications and quantity in an enquiry.
Manufacturer profiles associated with Cutting Teeth.
Explore company information and manufacturing capabilities, then discuss the scope of your project with a relevant supplier.
Replacement frequency depends on soil conditions, typically every 150-400 operating hours. Monitor for wear exceeding 30% of original length or visible cracking.
Limited re-sharpening is possible for some designs, but replacement is generally recommended as heat treatment properties degrade with repair attempts.
Conical or tiger tooth profiles provide better penetration in rocky conditions, while chisel profiles excel in cohesive soils.
Editorial classification, named public sources where available, and source-reviewed manufacturer records. See the editorial policy.